Shooters Forum banner

168gr Barnes TTSX load for 30-.06

13K views 10 replies 8 participants last post by  Barstool 
#1 ·
As the title says...I am loading for a load suggestions for my 30-06 using a barnes 168gr ttsx using IMR 4064 powder. Any other suggestions would be great.
 
#3 ·
As the title says...I am loading for a load suggestions for my 30-06 using a barnes 168gr ttsx using IMR 4064 powder. Any other suggestions would be great.


I shoot that bullet in Winchester cases ahead of a Federal 210 primer and 59 grains of H-4350 for 3020 FPS in a 26 3/4" Kreiger barrel
 
#8 ·
I shoot that bullet in Winchester cases ahead of a Federal 210 primer and 59 grains of H-4350 for 3020 FPS in a 26 3/4" Kreiger barrel
You are just the guy I want to ask. What was your loa? How far off the lands was your load? No trick question here. I just never had a lot of luck with this bullet & powder and and curious what you did different than I did (so far just the primer). Did it take high pressure before the extreme spreads settled down?

Thanks.
 
#6 ·
so your using the load data relating to the TSX bullets? Are those applicable to a TTSX bullet?



Where did you find the data for the H4350 powder...do you have the safe ranges for that/


TSX and TTSX bullets u the same data. Data for H-4350 is available from a multitude of sources, including but not limlited to ( Hogdon, Barnes, etc)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top