Shooters Forum banner

168gr Barnes TTSX load for 30-.06

13K views 10 replies 8 participants last post by  Barstool 
#1 ·
As the title says...I am loading for a load suggestions for my 30-06 using a barnes 168gr ttsx using IMR 4064 powder. Any other suggestions would be great.
 
#3 ·
As the title says...I am loading for a load suggestions for my 30-06 using a barnes 168gr ttsx using IMR 4064 powder. Any other suggestions would be great.


I shoot that bullet in Winchester cases ahead of a Federal 210 primer and 59 grains of H-4350 for 3020 FPS in a 26 3/4" Kreiger barrel
 
#8 ·
I shoot that bullet in Winchester cases ahead of a Federal 210 primer and 59 grains of H-4350 for 3020 FPS in a 26 3/4" Kreiger barrel
You are just the guy I want to ask. What was your loa? How far off the lands was your load? No trick question here. I just never had a lot of luck with this bullet & powder and and curious what you did different than I did (so far just the primer). Did it take high pressure before the extreme spreads settled down?

Thanks.
 
#9 ·
You are just the guy I want to ask. What was your loa? How far off the lands was your load? No trick question here. I just never had a lot of luck with this bullet & powder and and curious what you did different than I did (so far just the primer). Did it take high pressure before the extreme spreads settled down?

Thanks.


All I did was load to SAAMI COAL. I find that TSX thrive at the top end of loads. All barrels and chambers are different, other rifles may or may not like this load. Mine likes most loads and is easy to feed
 
#10 ·
All I did was load to SAAMI COAL. I find that TSX thrive at the top end of loads. All barrels and chambers are different, other rifles may or may not like this load. Mine likes most loads and is easy to feed
i have found that the tsx thrives at top loads also in my 375 and 22-250 i shot a 8x6 elk with one in a 375 and the performance was textbook my dad also took them to africa in a 300 wm and had the same results
 
#6 ·
so your using the load data relating to the TSX bullets? Are those applicable to a TTSX bullet?



Where did you find the data for the H4350 powder...do you have the safe ranges for that/


TSX and TTSX bullets u the same data. Data for H-4350 is available from a multitude of sources, including but not limlited to ( Hogdon, Barnes, etc)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top