Shooters Forum banner
headspace
1-5 of 5 Results
  1. Handloading Procedures/Practices
    HI, I have what might be a really stupid question. Is it true that the largest SAAMI cartridge will always fit in the smallest SAAMI chamber? I was/am prepping some brass I bought. I was full length sizing to make sure all the brass would fit in all my guns. I have opened the SAAMI specs...
  2. Handloading Equipment
    Ok, I am an experienced loader, but in experienced in the 300 win mag. Thus far I have only loaded new brass. I have sized it all and verified the COL to be below max. The sizing has been fairly easy as the case does not engage the shoulder or if it does it just engages the shoulder when the...
  3. Handloading Equipment
    Hello Fella's, Sorry to start another thread on sizing dies. This is sort of a spin off on, "New Guy Questions on Die Set Up" I'm not necessarily new to reloading but I'm forever learning. The man that taught me how to reload told me to set the sizing die by by screwing it down on until it...
  4. Gunsmithing
    I have a mannlicher schoenauer model 1950, in .270 cal. Half stock and a .23.5 inches barrel. The rifle used to be very accurate but suddenly lost accuracy. Since I saw no wearing off in the crown or rifling, I had it steel bedded, gave the barrel a thorough cleaning removing copper fouling...
  5. Gunsmithing
    I currently have a Remington 7600P chambered in .308 with an 18.5" carbine barrel on it. I was wondering if it were possible to swap the barrel to say a 22" .243 and after doing the necessary headspace adjustments, is it possible to then somewhat frequently interchange the barrels as necessary...
1-5 of 5 Results
Top