+1 He might try H-380, as when I owned a .22-250 (Ruger Model 77) I found this powder to be more consistant.
22-250 shooting left with reloads
I am fairly new to reloading but wonder how this could have anything to do with the bullets I loaded. Lots of variables because gun is new Savage varmiter with a Weaver Grand Slam 4.5x-14x 40mm scope. First round, I shot Remington factory loads with hollow points 50 gr.
I got it to shoot OK but newness of gun and especially the trigger led me to think most of the error was of my own doing. I checked the scope for level and found it to be a bit off so adjusted that.
Went to the range with Rem ammo and first shot understandable was off from the adjusting I did. Dialed in the change and fist shot just a bit right of center dot. Second shot touching on the high side. Satisfied it was dialed in properly.
First shot with reload of 36gr Varget using hornady v-max 50 gr head a bit low but almost two inches left. The wind was pretty strong and had shifted some from in my face to maybe 2:30. Fired again and this bullet hit at the same height abut a little bit more left maybe 1/4 or 1/2 inch. I thought it had to be the wind.
Then tried same bullet and head with 36.5 Varget. This bullet hit at the same height as the factory loads but once again was left. Second one left a bit more.
I gave up thinking the wind was just too much and it was cold as **** too.
When I got home went to the Winchester site and to their ballistic table. At 100 yards the wind pretty much has no impact at all.
I weighed each charge with two scales to make sure I was exactly on the number. I mic'd each case to make sure it was at the COL. The barrel is a very thick barrel so I do not think the heat was going to make it move. I did take time after each shot to check where the shot hit so there was at least 1 minute between shots and it was pretty cold. I had a thin barreled 243 that would start moving around if you shot it too much but do not expect this, especially on the 4th shot.
If I had any reason to believe that the movement was not the wind I would have fired another factory round but regrettably I did not.
I read that boat tails could be a bit finicky in the 22-250 so is this what I could expect. Oh shotting the 36 gr load the two hits were pretty close but left. The 36.5 was spread out a bit more. So I am thinking of loading some more with 36 gr but want to have a good handle on what happened before I do that. Any ideas, or experiences would be greatly appreciated.
I got it to shoot OK but newness of gun and especially the trigger led me to think most of the error was of my own doing. I checked the scope for level and found it to be a bit off so adjusted that.
Went to the range with Rem ammo and first shot understandable was off from the adjusting I did. Dialed in the change and fist shot just a bit right of center dot. Second shot touching on the high side. Satisfied it was dialed in properly.
First shot with reload of 36gr Varget using hornady v-max 50 gr head a bit low but almost two inches left. The wind was pretty strong and had shifted some from in my face to maybe 2:30. Fired again and this bullet hit at the same height abut a little bit more left maybe 1/4 or 1/2 inch. I thought it had to be the wind.
Then tried same bullet and head with 36.5 Varget. This bullet hit at the same height as the factory loads but once again was left. Second one left a bit more.
I gave up thinking the wind was just too much and it was cold as **** too.
When I got home went to the Winchester site and to their ballistic table. At 100 yards the wind pretty much has no impact at all.
I weighed each charge with two scales to make sure I was exactly on the number. I mic'd each case to make sure it was at the COL. The barrel is a very thick barrel so I do not think the heat was going to make it move. I did take time after each shot to check where the shot hit so there was at least 1 minute between shots and it was pretty cold. I had a thin barreled 243 that would start moving around if you shot it too much but do not expect this, especially on the 4th shot.
If I had any reason to believe that the movement was not the wind I would have fired another factory round but regrettably I did not.
I read that boat tails could be a bit finicky in the 22-250 so is this what I could expect. Oh shotting the 36 gr load the two hits were pretty close but left. The 36.5 was spread out a bit more. So I am thinking of loading some more with 36 gr but want to have a good handle on what happened before I do that. Any ideas, or experiences would be greatly appreciated.
1 - 1 of 42 Posts
1 - 1 of 42 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Shooters Forum
A forum community dedicated to Sport shooters, owners and enthusiasts. Come join the discussion about optics, hand casting bullets, hunting, gunsmithing, styles, reviews, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
