Shooters Forum banner
1 - 1 of 5 Posts

· Registered
1,944 Posts
Discussion Starter · #1 ·
I may have run this by you all once before but the memory lapses are coming more frequent.
I'm working on getting a new model 1895 in 30-06 or 270 then sending it off to a gunsmith of your recommendation to have it rebarreled to 375 Whelen.
I already have the dies and bullet molds for this caliber for use in my 375 bolt gun.
So my question is who would be a good gunsmith to send this project to.
This rifle will be cast bullet gun, since there's little to gained shooting jacketed stuff in it. Any recommendations as to barrel makers would be good also.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.