I’d like to ask a little advice and input – here goes: My Father’s fine old Winchester M1894 is circa 1918, (I ran the serial number). It is in 38-55 and shoots the Winchester factory 255 grain loads, (the bullets of which I milked at .377), very well. Given that, it is logical to assume that .377 is the proper groove diameter, correct? (I haven’t yet tried slugging the bore & given the prior statements, I feel that in this case it may not be necessary, right?) I just ordered some hard cast Hunter’s Supply 260 grain .376 diameter (Brinnel hardness 15) pre lubed bullets. I also ordered some Barnes Original .377 bullets in case the old rifle just flat doesn’t like the hard cast slugs. My questions are: 1) Do you learned folks think these hard cast (advertised as rated to 1600 FPS without gas checks) will perform in the no-bore-leading category as long as I hold velocities at or below 1600 FPS? And 2) [grass roots logic here] since many white tails are taken with jacketed, expanding .223 and .25 caliber bullets that probably expand to around the unexpanded diameter of he 38-55 slugs, is it commonly deemed ethical to use hard cast slugs in the 38-55 to hunt deer, (given reasonable ranges and careful shot placement)? Your advice would be appreciated. Thanks in advance.
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to Sport shooters, owners and enthusiasts. Come join the discussion about optics, hand casting bullets, hunting, gunsmithing, styles, reviews, accessories, classifieds, and more!