Shooters Forum banner
1 - 1 of 1 Posts

· Banned
86 Posts
I have not seen a 7.62X39 Imp. I do know some folks were necking it up to 35 cal and reboring Mini-30's for it. Supposed to be a pretty good round. If no one has designed a 7.62X39 Imp. yet why don't you? If you applied Ackley's usual method it should work out fine. You'll just need to make a drawing and send it off to Clymer and have them make the reamer. Then send a few fired cases off to RCBS and they'll whip up some dies.

I was wondering how those little CZ carbines were. They sound pretty good but I don't think I have seen any cataloged lately. Maybe I'll have to look around for one.

Good Luck

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.