Shooters Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
209 Posts
Discussion Starter · #1 ·
I just bought a "like new in box" .25-06 Ruger M77. The date of manufacture is Oct. 1985. Recently, I took it to the range, to see how it shoots, however I found that it would not chamber a round. This was Federal Premium factory ammo in .25-06. The bolt will come all the way forward, but will not cam down. The only thing I did to this rifle, was to disassemble the bolt for polishing. I took off the extractor, but did not remove the ejector, as the spring is very strong, and I do not have a tool for that. My question is, could I have reassembled the bolt incorrectly? It looks proper to me. The other question is, Could the previous owner have had the action 'trued' and rethreaded the barrel without ever having reset the headspace?  FYI: When I reassembled the bolt, I threaded it all the way in, then removed my strain relief, (temporary pin) thencounterclockwise till the little lug seated in it's notch.           "Ridge"
 

· Registered
Joined
·
209 Posts
Discussion Starter · #3 ·
Alk8944: Thank you for your response. Yes, the serial numbers do match. I am sending this rifle off for a trigger job, and general accurizing, so I will call my gunsmith, and let him know what is coming. I will find out in a week or two, and come back and let everyone know what it was. I looked for burrs, fragmented brass, etc. but found nothing with the naked eye. Take Care.........."Ridge"
 

· Registered
Joined
·
209 Posts
Discussion Starter · #5 ·
IDShooter: Yes, I can depress the spring all the way, but it is uncommonly strong. Too strong to depress and then drive out the pin to remove it. Need three hands......LOL. I am assuming there is a type of gripping tool for this purpose. Since I am sending it away, I may try once more to remove the ejector, and if successful, see if a round will chamber with it out of the bolt. Thanks for your response.     "Ridge"
 

· Registered
Joined
·
209 Posts
Discussion Starter · #6 ·
OK Guys, here is the answer: In polishing the bolt with my Dremel tool. I got jeweler's rouge packed down in around the plunger, to the point it wouldn't function properly. Kind of red faced to admit this, but possibly it will save someone else the same boo boo. The rifle will stay at the gunsmith's for accurizing......I am hoping it will group well with the 75 grain V-Max. This should make a nice long range varminter out of it......."Ridge" ... BTW,   ID Shooter: Good Call
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top