Shooters Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,943 Posts
I'd say your chances of success are dependent on the accuracy of your equipment.
There are swaging dies out there for use in reloading presses. These dies could do the swaging up you desire easily.
Once read an article in Handloader where the guy was using hollow point swaging dies to swage up and uniform the cast bullet.
Yes it doable and accurate.
<PLEASE DON"T TRY THIS>
Or Put your powder filled case in the chamber then drive the bullet from the muzzle until properly seated into the case. Then open bolt remove loaded round.

Jim
 
1 - 1 of 1 Posts
Top