Shooters Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
Hope this isn't some old subject. Does anyone know where I can find the thread diameter & pitch of nipples on Itialian copies of colt revolvers?
I realize I am being lazy but would like to be able to just go & buy a new set without tearing things apart first.
 

·
Registered
Joined
·
1,150 Posts
Charlie:

Usually 6x.75 mm but can be 6x1 mm too.  Best way, the packaging for most replacemnt nipples will tell you the brand of revolver/rifle they fit.  If you are ordering from other than the gun's maker then specify the make of gun when you order.

You should be satisfied with Uncle Mike's.  They have a good variety and good quality.
 

·
Registered
Joined
·
36 Posts
Discussion Starter #3
Thank you! 6x.75 it were. & yes Uncle Mikes fit the bill. They take a #11 cap instead of the #10 that the factory versions use. Problem solved.
 
1 - 3 of 3 Posts
Top