Shooters Forum banner
1 - 1 of 5 Posts

· Inactive
467 Posts
The 310 tool gets packed when I travel, I also take my size die from the bench press. If I NEED to full length size, I go to a buddys place (there's always someone that will let you use a press for a few minutes) to size shells, then take them where you're staying to finish loading. Also, Lyman USED to make full length size dies that were similar to the lee concept, just a die and a rod to knock them back out. They can still be found in old gun shops occasionally, or Randy at the "310 shop" has them sometimes. PS throw in a couple of lee powder dippers, and write down the charges each throws of various powders you use.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.