Shooters Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I am starting to reload  for .450 Marlin for the Marlin Guide Gun.  I have some 350 gr GC cast bullets from a SAECO mold.   The end of the bullet is flat but barely wider than the primer pocket.  Should I be concerned about firing these types of bullets from a gun with a tubular magazine?
Any help would be greatly appreciated.

Thanks, Mike
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.