Shooters Forum banner
1 - 1 of 1 Posts

· The Troll Whisperer (Moderator)
Joined
·
24,562 Posts
I have the Bonanza Co-Ax.

The Bonanza lock rings are a nice addition, but not absolutely required. The Lee lock rings that have the "O" ring on the underside work quite well, also. The problem you will run into with the rings supplied by the die makers will be a too small OD for the lock screw to secure, plus being made out of steel. There is a round ball and spring under the lock screw to set down on the ring to keep it in place. It actually detents the softer alloy Bonanza ring. If you can find the alloy rings which the older die sets had, you should be OK.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top