I am new to reloading and have a question concerning some 38 special 148 gr. double ended wad cutters (that is what is written on the box). I have some of these bullets but can't find loading info on them in any of my manuals (I have looked in 5 or 6). Most of my sources refer to a 148 gr. lead cast wadcutter, (LFP) lead flat point, (LBBWC) lead bevel base wadcutter, or just (WC) wadcutter. These bullets are flat on both ends with just a very small "nipple" on each end. Would any of the above listings match this bullet? I am planning on using "Clays" powder. Also, I have read that all wadcutters (except semi-wadcutters) should basically be loaded flush with the end of the brass. Is this correct? Any replys or literature suggestions would be appreciated. Thanks
lambo
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
