Shooters Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
294 Posts
Discussion Starter #1 (Edited)
I have three holsters for sale or trade, two right-handed and one left-handed. All are custom molded or fitted to hold Freedom Arms Model 83 revolver with six-inch barrel. Because FA 83s, Ruger Blackhawk, and some BFR revolvers have nearly identical profiles and configuration, the holsters may fit the others. These holsters are made from very heavy leather.
***
1. SOLD. Freedom Leather, right-handed, strong side thumb break holster with forward cant for up to 2.25-inch belt. Holster is in very good condition with burnishing of interior surfaces from revolver. . . . . $65.00 shipped.

2. SOLD. De Santis, right-handed, swivel-shoulder holster with thumb break. Holster is in very good-excellent condition. I would have identified the holster as being in excellent condition if it did not have a cosmetic leather scuff that is concealed when worn - I emphasize cosmetic. This holster was made for Ruger Blackhawk ten-inch revolver. I had Wes Daems of 7X Leather alter it and hand wet-mold to my FA 83 six-inch. . . . . . $90.00 shipped.

3. 7X Leather, left-handed, custom made cross-draw with 15-degree cant and integral safety strap is in excellent condition for up to 2.25-inch belt. This holster's strap was made as part of holster body. Strap fastens with stud rather than snap for durability and quiet operation. Trigger guard is partially enclosed. Holster has integral rear sight protector and basket weaving. . . . . $105.00 shipped.

Freedom Leather


De Santis - From my flatbed scanner I have attempted to show front and underside views of this unusually useful well made holster. Note the cosmetic scuff mark on second photo.


7X Leather

 

·
Registered
Joined
·
294 Posts
Discussion Starter #2
To the top
 
1 - 2 of 2 Posts
Top