Shooters Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3,251 Posts
If you remove the bolt, and cannot see any screw heads holding it on from the inside, it was most likely hard-soldered/"sweated" on.

HEAT will allow removal.......... AND receiver refinishing. :(

.
 

·
Registered
Joined
·
3,251 Posts
Keep your cool, AND the base - just sell the scope/ring/bracket combo, and let a buyer buy another base - which they'd most likely have to do anyway, unless they also have a Marlin.

The new 1" ring/bracket will fit the base that's on your rifle.

.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top