Shooters Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4,919 Posts
It will require a center fire firing pin as well. I have seen a couple of them done, and the process was to manufacture a new firing pin and re-drill the breach block. Easy method is to just dis-assemble breach block, cut off the firing pin tip and re-assemble the breach block assembly, and drill both the block and locate the proper location for the new tip on the old firing pin, dis assemble block assembly, drill old firing pin, and silver solder in short section of drill rod, Re-assemble and cut new pin to length, take back apart and radius tip, and re-assemble breach block for final time. The ones I saw didn't even fill the old firing pin hole.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top