Shooters Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I just purchased a used Lee loading press. I have some work to do as there is some rust that needs to be cleaned up but I lubed it up and it indexes into the detent ok. It has an indexing three position shell plate and I have the three hole die holders for the press. All of the information I have looked at shows a four position shell plate.

I quess I am looking for some direction to where I can get setup info for the press. Up to this point I have done all of my reloading with a single position press.

Thanks for any help.
Leon
 

·
Registered
Joined
·
1,009 Posts
Edit: I'm not sure from your description if you have a 3-position turret press or a Lee Pro 1000 progressive press.

Lee has instructions for the Pro 1000 online at http://www.leeprecision.com/cgi-data/instruct/TP2131.pdf

Lee has instructions for their turret press online at http://www.leeprecision.com/cgi-data/instruct/TP2131.pdf ... the 3-position and 4-position presses work the same way. You can also get an inexpensive upgrade kit to convert a 3-position turret press to the 4-position version. Lee part number 90933.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Thanks for the info.
I have a Pro 1000 press. I got to the Lee website and went through the catalog and downloaded what instructions I could find.
I have a little work to do and will need to get some new parts to get rolling.
 
1 - 3 of 3 Posts
Top