Shooters Forum banner

Locking Rings for Dies

3342 Views 13 Replies 10 Participants Last post by  unclenick
I just recently bought a new set of dies from RCBS and the locking ring is not the same size as it use to be. I am using them in an old Bonanza (Forester) press. The locking ring on the new dies is only about 1/4" thick. The rings I need are at least 5/16". There is just so much play in them it is impossible to get the same results in every case.

Are there new rings available anymore for the older equipment???

1 - 1 of 14 Posts
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.