Shooters Forum banner

Lyman 410639 mould

2303 Views 3 Replies 4 Participants Last post by  unclenick
Could anyone please supply information about this mould? I'm sure it's for .41 magnum bullets. I can't find any information on this mould. What weight bullet will it cast? Is it a gas check type bullet? All information will be appreciated. Thanks.
<!-- / message -->
1 - 1 of 4 Posts
thinking that one was for the .41 AE (Action Express).. a nice idea for a 41cal. semi-auto handgun that never caught on. Pretty much a .40SW before there was a 40S&W.

If i'm right, will cast a 170-175 truncated cone type bullet, no crimp groove, but can be used with .41mag cases if lightly crimped over the very start of the nose taper.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.