Shooters Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
447 Posts
Discussion Starter #1
Looking for a mold for .35 Remington .200 gr round nose, gas check.
Seem to be a lot of smaller molds and larger molds, I suspect are for hand gun and 35/70 etc.
Any suggestions?
 

·
The Hog Whisperer (Administrator)
Joined
·
36,718 Posts
Any reason you want round nose? If you are shooting a Marlin, I can recommend the RCBS 205gr. FNGC. At least I think that is what it's called.
 

·
Premium Member
Joined
·
1,021 Posts
Any reason you want round nose? If you are shooting a Marlin, I can recommend the RCBS 205gr. FNGC. At least I think that is what it's called.
My RCBS mould is marked 35-200-FN and is gas checked and my 35 Rem and .358 Win shoot them well.
They cast about 205-210 grains lubed and gas checked.
 

·
The Hog Whisperer (Administrator)
Joined
·
36,718 Posts
Thanks for the note re: the label, Mike. Somehow I thought they were marked 205gr.... although, as you note, that's what they end up weighing.
 

·
Registered
Joined
·
447 Posts
Discussion Starter #5
No, no particular reason for the round nose, will be shooting then out of a bolt Remington Model 600.
Just need a source.
Will look up "RCBS mould is marked 35-200-FN " @ RCBS
Thanks.
 

·
The Hog Whisperer (Administrator)
Joined
·
36,718 Posts
I don't know what the throat length on a Remington in that chambering is. You may have more options.

The Marlins have very short throats and it narrows down the choices quite a bit. Hope you find that you are looking for.
 
1 - 7 of 7 Posts
Top