Shooters Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
53 Posts
Discussion Starter · #1 ·
Hi-

  I'd like a little advice on a new mould purchase. The mould in question is produced by Ballisticast and for the .38/.357 but I have not yet decided which bullet design to choose. I can get it in 160 gr WFNPB or a 180gr WFN with or without a gascheck.
  They will be used in both an 1894 Marlin as well as a 686 primarily for plinking but may be used for hunting [I have some of Marshall's 185 grainers on the way which can take care of hunting needs]. I just want to make sure the choice I make is one that gives top accuracy with a variety of guns without going through hoops to get it and that it is versitle in its uses.
  All advice would be greatly appreciated.

God bless
Kevin
PS Awfully good to see you posting again Marshall!
 

· Registered
Joined
·
53 Posts
Discussion Starter · #3 ·
Hi Mike-

  That is what I hoped I would hear;-). If you don't mind a couple more questions...have you tried that bullet in a .38 case with lighter loads using HP-38 [say 5 grains] or Unique? What kind of 50 yard accuracy should I expect from an 1894 with the load you mention?

Thanks

God bless
Kevin
 

· Registered
Joined
·
53 Posts
Discussion Starter · #6 ·
Thanks for the help. I did the next best thing and ordered a four cavity mould with two cavities for each bullet. The mould should be arrive soon and I'll post the results of a variety of loads.

God bless
Kevin
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top