Shooters Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter #1
I'm sure that this question has come up before but I would like to put a stainless 1895 lever on a stainless 336. Is this possible?
 

·
Registered
Joined
·
35 Posts
Discussion Starter #2
I really need some knowlegable cowboy to respond to this question. I need to exchange levers and lower tangs on a 336 and an 1895. Is this possible?
 

·
The Hog Whisperer (Administrator)
Joined
·
36,441 Posts
I haven't done it, but the modern Marlin 1895 is pretty much a 336.

"Probably" if the parts don't normally require fitting at the factory, this may work.

I'd head over to Numrich gun parts, see if you can get a drawing of each gun with part numbers. If the same part numbers are listed, you're in business (keeping in mind that there is a straight lower tang and a curved lower tang.
 

·
Registered
Joined
·
35 Posts
Discussion Starter #4
Thanks Mike, I'll try Numrich Arms. I know that there is a straight and curved tang. That's the purpose in the question. I want a straight grip on a stainless 336 and Marlin doesn't make one for me. Edwin
 
1 - 4 of 4 Posts
Top