Shooters Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
I'd appreciate input on a pin guide/insertion tool that I've developed.

Note: Edited to remove advertising link.

A potential backer mentioned that it would be great for reassembling his AR-15, and could have quite a few gunsmithing applications.

The mark 2 incorporates solvent resistant materials, improved layout, and an organizational feature.

I recognize that the layout and locations for pin insertion will vary significantly based on the model of the firearm.

If you have any design improvements or recommendations I'd really appreciate it.

Thank you,
Adrian
 

·
The Troll Whisperer (Moderator)
Joined
·
24,020 Posts
Your post has been edited to remove the advertising link. You must have the board owner's permission to commercially advertise here. The Trading Post forum has a sub-forum for merchants with information on obtaining this permission.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top