Shooters Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
I'd appreciate input on a pin guide/insertion tool that I've developed.

edited to remove link

A potential backer mentioned that it would be great for reassembling his AR-15, and could have quite a few gunsmithing applications.

The mark 2 incorporates solvent resistant materials, improved layout, and an organizational feature.

I recognize that the layout and locations for pin insertion will vary significantly based on the model of the firearm.

If you have any design improvements or recommendations I'd really appreciate it.

Thank you,
Adrian
 

·
The Hog Whisperer (Administrator)
Joined
·
36,443 Posts
Hi, if you are interested in advertising on the forum, please use the "contact us" link at the bottom of each page. We appreciate your interest.

Thread locked.
 

·
The Troll Whisperer (Moderator)
Joined
·
24,022 Posts
Not only that - it's a double post. The very first post of this was "Moderated" and eventually died of natural causes.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top