Shooters Forum banner
Cancel

Reloading 44mag

3548 Views 15 Replies 12 Participants Last post by  Will-j, 
C
I am trying to use RCBS 44mag dies; but the resizing die is almost impossible to work. I lube my cases and have clean the die but it is so tight I can barely articulate the press. 44 mag cases are suppose to have an external diameter of .456; the die resizes down to .449 which is .007 smaller than the cases are supposed to be. Has anyone had this problem or heard of it before and if so what was done to correct the situation.
Reply
Save
Like
1 - 1 of 16 Posts
MikeG
Good grief get a carbide die. Having used the old steel dies only a time or two (for a wildcat cartridge), I can say you'll be amazed at the difference.

Life's to short to not use carbide resizing dies, when you can get them ;)
Reply
Save
Like
  • Like
Reactions: 4
1 - 1 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Shooters Forum
A forum community dedicated to Sport shooters, owners and enthusiasts. Come join the discussion about optics, hand casting bullets, hunting, gunsmithing, styles, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
Rifles and Rifle Cartridges Handloading Procedures/Practices General Discussion Handguns Gunsmithing
Top