Shooters Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Hi,
I just wanted to start a fresh thread now that I have it sort of installed...

With the Marbles sight installed and upright, there is ~1/4" of play forward and backward if you touch it a little. I wasn't expecting rock solid, but didn't expect it to easily move like that. Anyone else have this issue??

Also, in the screw set 995002 to replace the tang screws, the large screw doesn't want to screw in to the point that I have already buggered up the screwdriver slot. Should it be that hard? The screw hasn't even made it to the threaded part of the lower tang. I was using a hollow ground screwdriver but the slot is so narrow that I had to go with an 1/8" wide screwdriver tip.

I expect I may have to order another set.

Thanks!!

Adam
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #3 ·
Well, I did what the last poster in the 50caliberforum link suggested and the sight has minimal play now. Be careful of the small ball bearings. The first link I posted has pics of the disassembly process. I did not take it down farther than the first 4 pics showed.
adam
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top