Shooters Forum banner
1 - 2 of 2 Posts

·
Piney Woods Moderator
Joined
·
6,246 Posts
The need to size a cast bullet depends on how big it is when it drops from the mold. I have several molds that drop a bullet .002 over the bore size which is just right. I just tumble lube these and shoot them. Several of my molds drop bullets much to large to shoot so I have to size them within .002 of the bore. I tumble lube these first then run them through the sizing die and tumble lube again. I use several of the Lee Tumble lube molds with excellent success.
 

·
Piney Woods Moderator
Joined
·
6,246 Posts
I use mostly Lee aluminum block molds. For general all around shooting the Lee tumble lube bullets are hard to beat. Mold, tumble lube and shoot.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top