I've been eyeballing the hammer/trigger replacement with the roller bearing offered by Cylinder and Slide Shop.
Since I shoot the revolvers by pulling the trigger straight on through, by double action rather then single action, the roller bearing seems to make sense. It's my understanding that this set up is strictly double action only.
Has any one used this hammer/trigger combination? Does this setup require using one of the new Wolfe main springs?
Any info sure would help.
Jim
Since I shoot the revolvers by pulling the trigger straight on through, by double action rather then single action, the roller bearing seems to make sense. It's my understanding that this set up is strictly double action only.
Has any one used this hammer/trigger combination? Does this setup require using one of the new Wolfe main springs?
Any info sure would help.
Jim
