Shooters Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I just bought a real nice 03 rifle, it has had the rear sight, that was on the barrel removed and has had a Lyman recever sight installed, So the handguard now looks too short, and i am wondering if i was to get a handguard from an 03A3, since it is longer, if it would fit?  any one have any thoughts?
Thanks
 

·
Registered
Joined
·
1 Posts
Should work no problem,in addition to the 03A3 hanguard you will also need the stamped hanguard retainer that the 03A3 used.You will also need to remove the 03 sight base from the barrel.I'm assuming it is still in place as the o3 handguard would not stay on very well if it was already removed.

HTH,
Dave
 
1 - 2 of 2 Posts
Top