Joined
·
930 Posts
When mine was a couple years old, the break action became quite loose, and would open very easily (sometimes "on its own" at inoppertune times.
The fix ended up being to tighten the little block under the barrel where the hinge pin goes. There are two screws holding the block to the barrel, and they came loose. They need a T9 Torx driver. I almost boogered up mine trying to use an allen wrench before I realized it wasd a Torx. (No mention of this in the owner's manual.)
Just thought I'd post this in case it happens to any of your rifles.
The fix ended up being to tighten the little block under the barrel where the hinge pin goes. There are two screws holding the block to the barrel, and they came loose. They need a T9 Torx driver. I almost boogered up mine trying to use an allen wrench before I realized it wasd a Torx. (No mention of this in the owner's manual.)
Just thought I'd post this in case it happens to any of your rifles.