Shooters Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
291 Posts
Discussion Starter · #1 ·
Yesterday was my first session of bullet casting. I was quite pleased with the results. I did have one question. I am using a Lee Pro 4-20 furnace to melt my lead with. It was about half full of melted alloy. How much of the Marvelux should I add to the alloy to flux it? I noticed what looked like globs formed on top of the alloy after a time. I assume this was some of the alloys in the mix or am I wrong.I would appreciate any input.
 

·
Registered
Joined
·
291 Posts
Discussion Starter · #3 ·
Thanks for the information. I will check these sources out. It is nice to have someone to go to when you are a beginer. The insturctions don't include everything.
 

·
Registered
Joined
·
291 Posts
Discussion Starter · #7 ·
I would be interested in what you do use if you no longer use the Marvelux? Thanks for your good advice.
 

·
Registered
Joined
·
291 Posts
Discussion Starter · #12 ·
I want to thank kciH for answering a question that was rolling around in my head. How to clean the goop off of my ladle after removing the flux? I am soaking in this advice you guys are giving.
 
1 - 4 of 4 Posts
Top