Shooters Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter #1
Hope this note finds all is well with everyone.
I have a nice old Weaver K2.5 (all steel tube) Over the years it has performed well, however the 2-peice optics are seperating. I was wondering if anyone has had experience with Weaver Repair in , I,believe, El Paso Tx.?
Thanks!
Scott in Vermont
 

·
Registered
Joined
·
31 Posts
Scot

 I have had experience with a fellow in El Paso ,Texas with a Weaver scope. My advice is get hold of Weaver at 1-800-666-5761.
   tbc
 

·
Registered
Joined
·
88 Posts
Discussion Starter #3
I should have articulated a little better on my post. Caster: I was interested in results of Weaver Repair,(was the service timely, good workmanship etc.)
Thanks!
Scott
 

·
Registered
Joined
·
31 Posts
Scot
   The service was horrible , the repair ,after sending it back 3-time did not work and I had to send it to Weaver. By the way, belay that phone number sent you . It has been changed to 1-800-635-7656
   tbc
 

·
Registered
Joined
·
205 Posts
Caster, did you get the BAD repair service from the place on Larry Mahan Dr., in El Paso??  I have an older Weaver that needs repair and someone said that was where they Weaver scopes should be sent.

Thanks. L.W.
 

·
Registered
Joined
·
31 Posts
Leanwolf
    I dont remember the address this guy had, but if I were you and I had a problem with a Weaver scope , I would call Weaver at 1-800-635-7656 and see what they could do for you. NEVER would I get any body in Texas to do anything on my scope!!!
If you would send me an e-mail with the name of the person you are dealing with ,I'll tell you if it is him.Use the little thing above my name that says e-mail.
     tbc
 

·
Nawth East Moderatah
Joined
·
5,466 Posts
Boy your lucky I saw this post!  My K4 60-c just went sour 'bout a week ago. went to WEaver's site and recieved this info.
    Weaver scope repair service
    1121 Larry Mahan Dr.
    Suite B
    El Paso, TX
    79925
[915] 593-1005              I spoke to them this afternoon at 1530 est., they said if I send them the scope they will  repair the broken parts and give it a tune up including recharging it w/ nitrogen for about $40.00.  They also said they call B4 any work is done.
 The way I figure it is, I can't replace it with anything of the same quality for $40.00  <!--emo&:p--><img src="http://beartoothbullets.com/iB_html/non-cgi/emoticons/tounge.gif" border="0" valign="absmiddle" alt=':p'><!--endemo-->
 

·
Registered
Joined
·
205 Posts
Castor, thanks for 800 #. I called Weaver at that number and they gave me the # of the Weaver repair station in El Paso. 915-593-1005. Address is 1121 Larry Mahan Dr., El Paso, 79925.

The lady at Weaver said they handle all the repairs on Weaver scopes. Mine's an oldie-but-goldie V4.5.

Best of luck. L.W.
 
1 - 8 of 8 Posts
Top