Shooters Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
147 Posts
Okay. Hope I don't get jumped on to badly, but here is an idea. Lee Molds seem to always drop a little larger in diameter than listed. The 38 or 357 is a .358 diameter bullet, whereas the 9mm is .356. Lee makes a 1 ogive rn mold for the 9mm in 102grs. States it is .356. But it will drop larger. (I have found my Lee molds drop .002 to .003 larger than stated) Casting with wws the bullet should drop heavier and should be good fit to bore without sizing. Should get you pretty darn close to 110grs. with a rn bullet.
Just a thought.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top