Shooters Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,944 Posts
While working up the loads for my 375 Whelen, I was lucky to make contact with several people through the Cast Bullet Assoc.'s Fouling Shot who had been down that .380 road.
I found a couple of guys who had Lyman and RCBS molds that they had lapped out, milled down the top of the mold to remove the gas check shank, lapped the bullet nose. I was lucky to get a number of molds fairly inexpensively to experiment with.
This may be a path you'd like to follow.
Jim
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top