Shooters Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter #1
Looking for inner tube and spring/follower for a Winchester 600
Cooey .22
I've tried Brownells , Gunparts that usually stock them but
are all no stock.
Does anyone know of any company in the USA that would
likely have them. Or some that I could try, a few names would
be good. Thanks in advance.
 

·
Registered
Joined
·
11,948 Posts
Check out this link. It has a pretty complete accumulation of vendors of used gun parts.

 

·
Registered
Joined
·
65 Posts
Discussion Starter #3
Check out this link. It has a pretty complete accumulation of vendors of used gun parts.

Thanks Monty, Yeah, been thru most of them, lot don't post to Aust.
Googled lots of others and all negative, Just have to keep looking.
 

·
Premium Member
Joined
·
14,352 Posts
That's very simple part to make with a Brownell's kit. You can substitute a drill press for the minor lathe work that needs done. Use a gauge pin set to get the inner tube diameter right and the rest is pretty easy. Many hobby shops have thin-walled brass tubing in three foot lengths.
I don't have a Cooey here to measure for you.

I would think Aust. would be full of Canadian Cooeys. They were a favorite training rifles in the CW countries.
 

·
Registered
Joined
·
65 Posts
Discussion Starter #5
That's very simple part to make with a Brownell's kit. You can substitute a drill press for the minor lathe work that needs done. Use a gauge pin set to get the inner tube diameter right and the rest is pretty easy. Many hobby shops have thin-walled brass tubing in three foot lengths.
I don't have a Cooey here to measure for you.

I would think Aust. would be full of Canadian Cooeys. They were a favorite training rifles in the CW countries.
That was next on the list, make one, but still need the spring which I could get from Gunsprings.
There is plenty of Cooey over here but nobody wants to give me their inner tube.
.350 I think was the measurement ID of the outter tube.
 

·
Registered
Joined
·
65 Posts
Discussion Starter #6
Well finally got response from Numrich, they have some parts I want but
wont be international shipping till after the big flu.
Gunsprings has the spring but also no international shipping till
some time later.Looks like big wait unless I can get a 2nd hand one here in OZ.
Any .22 spring should fit as long as it's the right length
shouldn't it, I mean they should all be the same diameter shouldn't they.
I've ordered the tube for the inner and can make the plug and follower.
See what happens.
 
1 - 6 of 6 Posts
Top